Cortex VEXnet Manuel d'instructions télécharger pdf (Page 57)

ROBOTC

VEX Cortex Conguration over USB • 10

2011 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems

4. Move both joysticks through their full ranges of motion. When the remote control detects

that the joysticks have been fully rotated, the JOYSTICK LED stops blinking red and green,

and switches to a solid green.

There is a 10 second time limit to complete steps 4 and 5. If they are not completed in

time, the calibration process will timeout and the VEXnet LED will blink red briey.

Important - Time Sensitive Instructions

4a. Move the Joysticks

Move the joysticks through their full ranges of

motion - Up, Down, Left, Right, and in a circle.

4b. JOYSTICK LED

Once the remote control detects that the joysticks

have been fully rotated, the JOYSTICK LED switches

to solid green, indicating that you can stop moving

the joysticks.

VEXnet Joystick Conguration in ROBOTC (cont.)

Setup

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 94 95

Pas de commentaire

Cortex VEXnet Manuel d'instructions Page 57