Cortex VEXnet Manuel d'instructions télécharger pdf (Page 65)

ROBOTC

Download ROBOTC User Firmware • 2

2007 Carnegie Mellon Robotics Academy / For use with VEX Robotics Systems

2. Plug the free USB connector end of the Programming cable into a USB port on your computer.

Plug the other unconnected end of the cable into the “SERIAL” port of your VEX Microcontroller.

2a. ConnectUSBtoPC

Plug the remaining USB

connector on the USB-to-Serial

Cable into the PC.

2b. Connect“phone”toVEX

Plug the loose RJ25 “phone”

connector into the SERIAL port

on the VEX Microcontroller.

When you plug in the

USB-to-Serial Cable, your

computer may prompt you

to install new hardware.

If this happens, it is because

your computer does not

have the proper drivers

installed to operate the

USB-to-Serial Cable.

Complete the steps in the

Driver Installation Guide

to install the drivers, then

continue with this lesson.

Drivers Needed Error

Download ROBOTC User Firmware (cont.)

Setup

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 94 95

Pas de commentaire

Cortex VEXnet Manuel d'instructions Page 65