Cortex VEXnet Manuel d'instructions télécharger pdf (Page 61)

ROBOTC

Master Firmware Download • 2

Carnegie Mellon Robotics Academy / For use with VEX

Robotics Systems

Setup

Master Firmware Download Instructions (cont.)

2. Power the VEX Microcontroller and connect it to your computer using the orange

USB-to-Serial programming cable.

2a. PowertheVEXMicrocontroller

Connect the VEX Microcontroller to a

charged 7.2V battery and turn it ON.

2b. ConnecttheVEXtotheComputer

Use the orange USB-to-Serial programming cable to

connect the VEX to your computer. If you are using the

VEXnet Microcontroller Upgrade, temporarily unplug

it from the SERIAL port.

Note: You must have the driver for the USB-to-Serial

programming cable installed on your computer. You

can download the driver at www.ROBOTC.net.

When you plug in the USB-to-Serial

Cable, your computer may prompt

you to install new hardware.

If this happens, it is because your

computer does not have the proper

drivers installed to operate the

USB-to-Serial Cable.

Complete the steps in the Driver

Installation Guide to install the

drivers, then continue with this lesson.

Drivers Needed

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 94 95

Pas de commentaire

Cortex VEXnet Manuel d'instructions Page 61